Connector Hose Washout Port 95-3270 Compatible with Toro Time Master Cutter 4200SS SS5000 SS5060 Lawnboy Wheelhorse Exmark S-Series E-Series Quest Quest (1)

What It Is

This is the OEM replacement connector hose for the washout port on select Toro, Exmark, and Lawnboy mowers. It lets you attach a garden hose to flush grass and debris from the underside of the cutting deck without removing the blade or tipping the mower.

Fitment & Compatibility

Before buying, confirm your mower has a factory-installed washout port fitting—this hose connects the port to the deck. It fits Toro TimeMaster, Cutter 4200SS, SS5000, SS5060, Wheelhorse, and Exmark S-Series, E-Series, and Quest models (2010–2020). It also fits some Lawnboy decks. Measure the existing hose length (roughly 6–8 inches) and check that the barbed ends match your port and deck inlet. This is an OEM Toro part (95-3270), so it’s a direct swap for the original. Aftermarket hoses may have slightly different ID/OD, causing leaks or poor fit.

Key Things to Know

• Quality: Made from reinforced rubber, resists cracking from heat and UV better than generic vinyl hoses.
• Installation: Easy—remove the old hose by prying off the spring clamps, slide on the new one, and reinstall clamps. No tools beyond pliers needed.
• Common gotcha: The hose can kink if routed tightly; ensure it has a gentle curve to avoid blocking water flow.
• Check clamps: The original spring clamps often rust or lose tension; consider replacing them with stainless steel worm-drive clamps for a secure seal.

Should You Buy It

If your mower’s washout hose is cracked, leaking, or missing, this OEM replacement is the correct fix. It’s a cheap, 5-minute repair that restores deck cleaning performance. Skip it if your port fitting itself is damaged (you’ll need the full port assembly) or if you’re using a non-compatible mower.