Toro BLD KT HGH Lift 50"

What It Is

The Toro BLD KT HGH Lift 50" is a high-lift blade set designed for Toro TimeCutter and Titan zero-turn mowers with 50-inch decks. It improves grass discharge and bagging performance in thick, tall, or wet grass conditions.

Fitment & Compatibility

• Deck size: 50-inch fabricated deck only (not stamped). Measure your deck width before buying.
• Models: Fits Toro TimeCutter (e.g., SS5000, SS5025, MX5050) and Titan (e.g., TX525, TX1000) series with 50" decks. Check your model number on the frame tag.
• OEM vs aftermarket: This is an OEM Toro part (BLD KT HGH Lift 50"), not a generic blade. Aftermarket blades may differ in thickness, hole size, or lift angle—stick with OEM for guaranteed fit.
• Measurements: Each blade is approximately 20.5 inches long, with a 1-inch center hole and 7/8-inch offset. Verify your spindle bolt size (typically 5/8" or 3/4") to match included hardware.

Key Things to Know

• Installation difficulty: Moderate. You’ll need a socket wrench, torque wrench (50-60 ft-lbs), and jack or lift to access the deck. No special tools required.
• Quality: 4.8 stars from 1,051 reviews—users consistently report sharp edges, balanced blades, and noticeable lift improvement over stock. Made from heat-treated steel.
• Common gotchas: These blades are heavier than standard blades, which may increase engine load slightly. Not for mulching—use only for bagging or side-discharge. Always replace all three blades at once to maintain balance.
• Wear check: Inspect for bent or dulled blades after each season; high-lift blades wear faster in sandy or rocky conditions.

Should You Buy It

Yes—if you own a Toro 50" zero-turn and struggle with clumping or poor bagging in heavy grass, this is a proven upgrade. Skip it if you primarily mulch or cut dry, short turf; standard blades will be quieter and more efficient.