Throttle Control Cable Compatible with Wright WS32 WS36 Stander 48" 52" 61" Deck Lawn Mowers, Replacement for 52420002, 19729-26979

What It Is

This throttle control cable replaces the original cable that connects the control lever to the engine carburetor on Wright WS32 and WS36 Stander zero-turn mowers. It lets you adjust engine speed (idle to full throttle) and is intended for decks sized 48", 52", or 61".

Fitment & Compatibility

Before buying, verify your mower’s model and deck size: this cable fits Wright WS32 and WS36 Stander models with 48", 52", or 61" decks. It replaces OEM part numbers 52420002 and 19729-26979. Check the cable length (measure from the control lever mount to the carburetor linkage) and compare to your original—this replacement is a direct drop-in for those specific Wright models. If your mower is a different brand or an older Wright variant (e.g., WS42), it likely won’t fit.

Key Things to Know

• Installation difficulty: Moderate. You’ll need basic hand tools (screwdriver, pliers) and about 20–30 minutes. No special skills required, but take photos of the old cable routing before removal.
• Quality: This is an aftermarket part, not OEM Wright. Build quality is solid for the price, but the outer sheath may be slightly stiffer than the original—expect a minor break-in period for smooth operation.
• Common gotcha: The cable end fittings are pre-attached, but you may need to adjust the carburetor linkage travel after installation. If the engine won’t reach full RPM, loosen the cable clamp and fine-tune the length.
• Rust/corrosion: If you store the mower outdoors, apply a light oil to the exposed cable ends to prevent sticking.

Should You Buy It

If you own a Wright WS32 or WS36 Stander with a 48", 52", or 61" deck and need a budget-friendly replacement for a worn or snapped throttle cable, this is a solid choice. It’s not for other Wright models or brands, and you’ll need to do a simple adjustment after install. At $18.99, it’s a good value for a functional repair.