Throttle Cable 532183281 183281 for Craftsman 917 Husqvarna 6021P 7021P Parts Poulan Weed Eater Rotary Lawn Mower Engine Zone Control Cable Jonsered Walk Behind Lawn Mower 198463 198463

What It Is

This throttle cable (OEM part number 532183281 / 183281) controls engine speed on select Craftsman, Husqvarna, Poulan, Weed Eater, and Jonsered walk-behind lawn mowers. It connects the throttle lever to the engine carburetor, letting you adjust RPMs for cutting, mulching, or idling.

Fitment & Compatibility

Before buying, check these three things:

• Model number, not brand name: This cable fits specific models—Craftsman 917 series, Husqvarna 6021P/7021P, Poulan/Weed Eater rotary mowers, and Jonsered walk-behinds. Look for a “917” or “6/7021” prefix on your mower’s model tag (under the deck or on the frame).
• Cable length: OEM cable is approximately 36 inches end-to-end. Measure your old cable from housing end to housing end. If yours is longer or shorter, this won’t work.
• Housing ends: Both ends have a standard barrel fitting (approx. 5/16” diameter). The carburetor end uses a small loop or Z-bend. If your mower has a different connector style (e.g., threaded or clip-on), this won’t fit.

OEM vs aftermarket: This is an OEM replacement (Craftsman/Husqvarna part), not generic. It matches factory specs exactly.

Key Things to Know

• Installation is moderate: You’ll need a screwdriver and possibly pliers. Route the cable away from hot engine parts and moving blades. Most mowers have a retaining clip or screw near the carburetor.
• Adjustment needed after install: Loosen the cable lock nut, pull the cable taut (but not tight enough to open the throttle), then tighten. Test by moving the throttle lever—it should snap back to idle.
• Common gotcha: The cable housing can kink if bent sharply during routing. Avoid tight 90-degree bends—use gentle curves. A kinked cable will bind and cause erratic speed control.
• Quality note: At 4.0 stars from 880 reviews, most users report it works as a direct fit. A few mention the cable is slightly shorter than some older OEM versions—measure first.

Should You Buy It

If you have a Craftsman 917, Husqvarna 6021P/7021P, or compatible Poulan/Weed Eater/Jonsered walk-behind mower and your throttle cable is frayed, sticky, or broken, this is the correct, affordable replacement. It’s a solid choice for DIY repair—just verify your model number and cable length before ordering. Skip it if your mower uses a different connector type or a longer cable.