Podoy 946-04661A Control Cable Compatible with MTD 946-04661 746-04661 746-04661A,TroyBilt TB100 TB110 TB115, Craftsman,Yardman, 51 inch Lawn Mower Throttle Cable

What It Is

This is a replacement control cable that connects the throttle lever to the engine carburetor, allowing you to adjust engine speed on walk-behind mowers. It’s designed for 51-inch and smaller MTD-built mowers, commonly used on Troy-Bilt, Craftsman, and Yardman models.

Fitment & Compatibility

Before buying, check these three things:

• Model number: The cable fits MTD 946-04661, 746-04661, and 746-04661A. It also works on Troy-Bilt TB100, TB110, TB115, and many Craftsman/Yardman models with similar throttle assemblies.
• Cable length: Measure your old cable end-to-end (including fittings). This cable is about 51 inches long. If your original is shorter or longer, it may not route properly.
• End fittings: Verify both ends match—one end has a barrel for the lever, the other a loop or Z-fitting for the carburetor. This is an aftermarket part, not OEM, so fitment can vary slightly on older mowers.

Key Things to Know

• Quality is decent for the price – The cable housing is plastic, and the inner wire is steel. It won’t last as long as an OEM cable, but it’s a solid budget fix.
• Installation is moderate – You’ll need to remove the old cable, route the new one along the handlebar, and adjust the tension. Expect 20–40 minutes if you’ve done it before.
• Common gotcha: The cable may be slightly too long or short on some models. Test routing before cutting any zip ties. If it’s tight, you might need to re-route or add a small spacer.
• Not for zero-turn or riding mowers – This is strictly for push mowers and walk-behinds with a single throttle lever.

Should You Buy It

Buy this if you have a MTD, Troy-Bilt, Craftsman, or Yardman push mower with a snapped or sticky throttle cable and want a cheap, functional fix. It’s not a lifetime part, but for $7.99 it’s a practical stopgap that gets your mower running again quickly.