Maxpower 561136B 3-High Lift Blade Set for Many 60 in. Cut Exmark Mowers Replaces OEM #'s Bad Boy 038-2007-00, 038-6050-00, Exmark 633483, Toro 105771803

What It Is

This is a set of three high-lift blades designed for 60-inch cut Exmark mowers and compatible Bad Boy and Toro models. The high-lift design increases airflow for superior grass clipping discharge and bagging performance, making it ideal for commercial or residential mowing where clean cut and debris evacuation are critical.

Fitment & Compatibility

Before buying, verify your mower has a 60-inch cutting deck—this set fits three-blade decks only. Check OEM part numbers: Bad Boy 038-2007-00, 038-6050-00; Exmark 633483; Toro 105771803. Measure blade length (should be ~20.5 inches), center hole diameter (must match your spindle), and thickness (typically 0.203–0.250 inches). Confirm your mower’s spindle bolt pattern and blade orientation (high-lift curves upward). Not for zero-turn or side-discharge decks requiring low-lift or mulching blades.

Key Things to Know

• Quality: Maxpower blades are heat-treated and hardened, but may be slightly thinner than OEM Exmark/Toro blades—check spindle clearance to avoid contact.
• Installation: Moderate difficulty; requires a blade removal tool and torque wrench. Tighten to 70–90 ft-lbs, but verify your mower’s spec. Use thread-locker on bolts.
• Gotchas: High-lift blades increase engine load and fuel consumption—expect slightly reduced runtime. They can also throw debris farther; keep bystanders clear.
• Balance: Each blade is balanced from factory, but always recheck after sharpening. Unbalanced blades cause vibration, spindle wear, and uneven cut.

Should You Buy It

Buy this if you need a cost-effective replacement for a 60-inch Exmark, Bad Boy, or compatible Toro mower and prioritize bagging or clean side-discharge performance. Skip it if you mow in dusty or sandy conditions (high-lift blades wear faster) or require OEM-specific thickness for precise deck fit.