Lawn Mower Blade Control Handle 747-05214D Compatible with MTD, Troy Bilt, Craftsman, Yard Man for 11A-A26M011 (2010)

What It Is

This is a replacement blade control handle (part number 747-05214D) for walk-behind lawn mowers, designed to engage and disengage the blade brake clutch system. It’s intended for MTD, Troy-Bilt, Craftsman, and Yard Man mowers, particularly the 11A-A26M011 model from 2010.

Fitment & Compatibility

Before buying, verify these three things:

• Model number: The 11A-A26M011 (2010) is confirmed compatible, but check your mower’s model tag (usually under the seat or on the deck) for a direct match.
• Handle type: This is a curved, plastic-coated steel handle with a specific mounting hole spacing (about 4.5 inches center-to-center). Measure your old handle’s hole distance to confirm.
• OEM vs aftermarket: This is an aftermarket replacement for OEM part 747-05214D. It fits many MTD-built mowers with similar blade control systems, but not all—cross-reference with your original part number if possible.

Key Things to Know

• Installation is straightforward: Remove the old handle by pulling the cable end out of the bracket, then snap the new one in place. No special tools needed.
• Check cable tension: After installing, ensure the blade engages fully when the handle is pulled back. If it feels loose, adjust the cable at the bracket—most mowers have a simple screw adjuster.
• Handle material feels sturdy: The plastic grip is molded over a steel core, but it can crack if overtightened or if the mower is dropped. Use hand-tighten bolts only.
• Common gotcha: The handle may not fit mowers with different deck sizes or cable routing paths (e.g., 21-inch vs 22-inch decks). Always measure your old handle length (about 10 inches overall) to compare.

Should You Buy It

Yes, if you have a compatible MTD/Craftsman/Troy-Bilt mower from the 2010 era and your original handle is broken or worn. It’s a cheap, easy fix that restores blade control safety. Skip it if your mower uses a different handle design or if the cable is damaged—you’ll need to replace that too.