(HRN216) Original Equipment Blade Set - 72511-VR8-M00A,Replacement for Honda OEM

What It Is

This is an OEM Honda blade set (part #72511-VR8-M00A) designed exclusively for the HRN216 walk-behind mower. It includes two blades that work together in Honda’s twin-blade “MicroCut” system to produce a finer clip and better bagging performance than single-blade decks.

Fitment & Compatibility

Before buying, confirm your mower model is HRN216 (e.g., HRN216VKA, HRN216VLA, HRN216VYA). This set will not fit HRX, HRR, or other Honda series. Check your deck size: the HRN216 has a 21-inch cutting width, and these blades measure approximately 21 inches end-to-end. If you have an aftermarket blade adapter or a non-Honda spindle, this OEM set may not align correctly. Always verify the blade bolt pattern—Honda uses a specific center hole and offset that aftermarket blades sometimes get wrong.

Key Things to Know

• Quality: Genuine Honda steel with factory edge hardening. Expect 25–40 hours of cutting life on a typical lawn before dulling.
• Installation: Easy—just remove the single center bolt per blade. Torque to 35–40 ft-lbs. No special tools needed beyond a socket wrench.
• Gotcha: The two blades are different lengths (one is slightly shorter). Don’t swap them side-to-side; the longer blade goes on the left (from operator’s position). Installing reversed causes vibration and poor cut.
• Sharpening: Not recommended—these are thin, hardened blades that lose temper if ground. Replace instead.

Should You Buy It

If you own an HRN216 and want reliable, drop-in fit with the same cut quality as when new, this is the right choice. At $40, it’s more expensive than generic sets, but you avoid vibration, poor bagging, and premature wear from mismatched aftermarket blades. Skip it only if you’re on a tight budget and willing to gamble on a $15 universal set.