Bush Hog 10" Solid Molded Finish Mower Wheel Assembly 1" Yoke with Needle Bearings 2PK

What It Is

This is a pair of 10-inch solid molded finish mower wheels, each pre-assembled in a 1-inch yoke with sealed needle bearings. They’re designed for zero-turn and finish mower decks (e.g., Bush Hog, Bad Boy, Hustler) where a smooth, low-profile wheel is needed for close trimming.

Fitment & Compatibility

• Wheel size: 10 x 3.5 (typical), solid molded tire – no air, no flats.
• Yoke width: 1 inch (inside width where the wheel mounts). Measure your existing yoke gap; this won’t fit a 3/4-inch or 1.25-inch yoke.
• Bolt pattern: Yokes use a 5/8-inch or 3/4-inch spindle bolt (check your mower’s spindle shaft or bolt diameter).
• Deck clearance: Confirm your deck has at least 10.5 inches of vertical space for the wheel to rotate freely.
• Brand crossover: Commonly fits Bush Hog, Bad Boy, Hustler, and many aftermarket finish mower decks. Not for residential push mowers or heavy-duty rough-cut decks.
• OEM vs aftermarket: This is an aftermarket assembly. Verify your OEM part number (e.g., Bush Hog 1-075X or similar) matches the yoke and bearing specs.

Key Things to Know

• Needle bearings: Pre-greased and sealed – no maintenance needed, but they are not serviceable. If they fail, you’ll replace the whole assembly.
• Solid tire: No flats, but rides harder on uneven turf. Best for flat, manicured lawns.
• Installation: Direct bolt-on if spindle and yoke width match. You may need a new spindle bolt or washers to align the yoke. No special tools beyond a socket/wrench.
• Weight: Each assembly is about 5–6 lbs – light enough for easy handling but sturdy enough for commercial use.

Should You Buy It

If you need a reliable, flat-free replacement for a 10-inch finish mower wheel on a zero-turn or finish mower deck, and your yoke is 1 inch, this is a solid buy. The high rating and sealed bearings make it a good value for commercial or residential use. Skip it if you need a pneumatic tire for rough terrain or a different yoke size.