946-05124A Blade Engagement Cable for Craftsman T110 Parts, MTD, Troy Bilt, Murray, Huskee Mower Parts, Replaces 946-05124A 746-05124A Deck Engage Cable

What It Is

This is a replacement blade engagement cable for riding mowers with a manual lever-operated deck. It connects the dash lever to the mower deck’s idler pulley, allowing you to engage or disengage the blades. Designed for Craftsman T110 and similar MTD-built models.

Fitment & Compatibility

Before buying, confirm your mower uses a manual cable (not an electric PTO switch). This cable fits many Craftsman T100/T110/T120 series, Troy Bilt TB30/42, Murray, and Huskee models with 42-inch or smaller decks. Measure your original cable’s overall length—this replacement is roughly 60 inches from end to end. Check that both end fittings match: one end has a barrel-shaped connector for the lever, the other has a clevis pin hole for the deck bracket. OEM part numbers 946-05124A and 746-05124A are direct cross-references. If your mower has a different cable routing or a spring-assisted tensioner, this cable may not fit.

Key Things to Buy

• Quality: This is a budget aftermarket cable. It works, but the outer jacket is less flexible than OEM, making routing a bit stiffer.
• Installation difficulty: Moderate. You’ll need to remove the dash panel and deck belt shield. Expect 30-60 minutes if you’re handy with basic tools.
• Common gotcha: The cable can kink if bent sharply during installation. Route it smoothly, avoiding tight turns near the engine or frame.
• Adjustment: After installing, you may need to adjust the cable tension at the deck bracket so the blade lever locks firmly in the engaged position.

Should You Buy It

If you need a quick, low-cost fix for a broken or stiff engagement cable on a Craftsman T110 or similar MTD lawn tractor, this cable will get you mowing again. It’s not premium quality but works fine for light to moderate residential use. Avoid it if you need a precise OEM fit or have a larger deck with a different cable routing.