946-04728A Single Speed Drive Cable Compatible with MTD Craftman Troy-Bilt M210 M220 TB200 TB210 TB430 Lawn Mower, Replaces 746-04728, 746-04728A, 946-04728

What It Is

This is a single speed drive cable that connects the drive control handle to the transmission on select MTD, Craftsman, and Troy-Bilt walk-behind lawn mowers. It engages and disengages the self-propel mechanism, so when you squeeze the control bar, the cable pulls the transmission lever and the mower moves forward.

Fitment & Compatibility

Before buying, verify your mower model. This cable is confirmed to fit Troy-Bilt TB200, TB210, TB430, M210, and M220 models, plus Craftsman and MTD equivalents with a single-speed (not variable-speed) self-propel system. Check your original part number—this replaces OEM 746-04728, 746-04728A, and 946-04728. Measure the cable length: it’s roughly 38 inches from end to end. If your mower has a different cable length or a two-speed/ variable-speed drive, this will not work. Also confirm your deck size is between 21" and 22" (common for these models). Look for a stamped part number on your old cable or check your owner’s manual.

Key Things to Know

• Quality vs OEM: This is an aftermarket replacement, not a genuine MTD/Troy-Bilt part. It’s functional and well-reviewed, but the plastic ends may feel slightly less durable than OEM. Should hold up for a season or two under normal use.
• Installation difficulty: Moderate. You’ll need basic hand tools (pliers, screwdriver, maybe a socket). The hardest part is routing the cable correctly and adjusting the tension. Allow 20–40 minutes.
• Common gotcha: The cable can be too long or too short if you don’t match the routing exactly. Before tightening, loop it through the same clips and brackets as the old one. If the self-propel doesn’t engage fully, adjust the cable barrel adjuster at the handle.
• Compatibility note: This is for single-speed only. If your mower has a variable-speed (twist-grip) drive, this cable won’t fit.

Should You Buy It

If you have one of the listed MTD/Craftsman/Troy-Bilt models with a single-speed drive and your original cable is stretched, frayed, or snapped, this is a solid, low-cost fix. It won’t match OEM fit and finish exactly, but for $11.59 it’s a practical replacement that gets the job done. Avoid it if you need a two-speed or variable-speed cable.