8TEN LawnRAZOR Mower Blade for Toro Recyclers Steel 22 inch Decks 108-9764-03 104-8697-03 131-4547-03 (Mulching) 2 Pack

What It Is

This 2-pack of 8TEN LawnRAZOR mulching blades is designed for Toro Recycler mowers with 22-inch steel decks, replacing OEM part numbers 108-9764-03, 104-8697-03, and 131-4547-03. It’s for users who want fine grass clipping mulching without bagging or side-discharge.

Fitment & Compatibility

• Deck size: Must be 22 inches (measure your deck, not the blade length—blade length is roughly 21.5 to 22 inches).
• Toro models: Fits most Toro Recycler models with steel decks (e.g., 20052, 20332, 20333, 20339, 20340, 20370). Check your mower’s model number under the seat or deck.
• OEM cross-reference: These replace Toro 108-9764-03, 104-8697-03, and 131-4547-03. If your blade has any of these numbers stamped on it, these fit.
• Center hole: 8-point star (7/8-inch center hole). Verify your spindle matches—most Toro Recyclers use this, but older or non-Recycler models may not.
• Blade length: Measure your old blade from tip to tip; if it’s 22 inches, these match. Do not rely on deck size alone.

Key Things to Know

• Mulching performance: The LawnRAZOR design has a curved, high-lift wing and serrated edge for fine clippings. Works best with dry grass and sharp blades—dull blades tear grass.
• Installation: Straightforward with a socket wrench and torque wrench (recommended 50-60 ft-lbs). Use thread locker (Loctite) on spindle bolts to prevent loosening. Blade bolt size is typically 5/16-inch.
• Balance: These are pre-balanced, but always check on a blade balancer after install. An unbalanced blade causes vibration and bearing wear.
• Not for bagging: These are pure mulching blades. If you bag or side-discharge, look for a different profile (e.g., Gator or standard lift blade).

Should You Buy It

Buy this if you have a Toro Recycler with a 22-inch steel deck and want an affordable, durable mulching upgrade that cuts finer than OEM. It’s not for bagging or non-Recycler models. For $29.95 (2-pack), it’s a solid value—just verify your blade length and center hole before ordering.