72610-VG3-030 Blade Holder Set for Honda HRR216K6 PDAA HRR216K6 VKAA HRR216K7 PDAA Models, Also w/ 90105-960-710 Mower Blade Hex Bolts and 90502-VG3-000 Spring Ring

What It Is

This is a genuine OEM blade holder set for Honda HRR216 series mowers, designed to secure the blade to the crankshaft. It includes the blade holder itself, two hex bolts (90105-960-710), and a spring ring (90502-VG3-000) – everything needed for a proper blade mounting assembly.

Fitment & Compatibility

Exact models: HRR216K6 PDAA, HRR216K6 VKAA, HRR216K7 PDAA. Also fits other Honda HRR216 variants with the same blade mounting system.
What to check:

• Deck size: Works with 21-inch decks on these models.
• Bolt thread: M8x1.25 (standard Honda).
• OEM vs aftermarket: This is genuine Honda – aftermarket holders may differ in thickness or bolt hole alignment.
• Measurement: Hold your old holder flat and measure the center hole diameter (should be ~28mm) and the bolt hole spacing (two holes ~60mm apart).

Key Things to Know

• Quality: Genuine Honda steel – holds up better than many aftermarket stamped holders.
• Installation: Moderate difficulty. You’ll need a torque wrench (spec: 40-50 ft-lbs for the hex bolts).
• Gotcha: The spring ring must be fully seated in its groove – if it’s not, the blade can loosen during use.
• Reuse: If you’re only replacing the blade, you don’t need this set unless the holder is bent or the bolts are stripped.

Should You Buy It

Buy this if your original blade holder is bent, cracked, or the bolts are worn. It’s a direct OEM replacement for HRR216K6/K7 models – no guesswork, no fitment issues. Skip it if you just need a blade; buy the blade alone instead.