703562 Drive Cable-Fits for Snapper & Briggs and Stratton Lawn Mowers,Compatible with SP65-550, SP65-625, SP70-675 Self Propelled Walk Behind Mower

What It Is

The 703562 drive cable is a replacement control cable that engages and disengages the self-propel drive system on Snapper and Briggs & Stratton walk-behind mowers. It’s designed for SP65-550, SP65-625, and SP70-675 self-propelled models.

Fitment & Compatibility

Before buying, verify your mower’s model number (found on the engine shroud or frame). This cable fits Snapper SP65-550, SP65-625, and SP70-675 series specifically. It also works with some Briggs & Stratton-powered mowers using the same chassis. Measure the existing cable’s overall length—this replacement is approximately 45 inches from end to end. Check the cable hook and ferrule ends match your mower’s handle and drive mechanism. If your mower uses a different cable routing or has a different handle design, this won’t fit. OEM part number 703562 is a direct replacement; aftermarket versions may vary slightly in length or end fittings.

Key Things to Know

• Quality & durability: This is an OEM-grade cable with a metal outer sheath and nylon inner liner—resists kinking and corrosion better than generic cables.
• Installation difficulty: Moderate. You’ll need to remove the handle cover, detach the old cable from the drive lever and transmission, then route the new cable following the same path. A pair of pliers and a 10mm wrench are usually sufficient.
• Common gotcha: The cable can bind if not routed exactly as the original—avoid sharp bends or pinching against the handle. Check that the cable moves freely before tightening any clamps.
• Lubrication: Apply a light oil (like WD-40 or cable lube) to the inner cable after installation to reduce friction and extend life.

Should You Buy It

If your Snapper SP65 or SP70 self-propelled mower’s drive cable is frayed, kinked, or no longer engages smoothly, this is a solid OEM-spec replacement. It’s a direct fit for the listed models and priced reasonably for a quality cable. Skip it if your mower isn’t in the SP65-550/625 or SP70-675 series, or if you need a cable for a different brand or a non-self-propelled model.