54530-VL0-S01 Brake Cable Fit for Honda HRR216 HRX217 HRN216VKA HRR216K9VKAA Series Walk-Behind Mowers, Lawn Mower Drive Cable

What It Is

This is the OEM Honda brake cable (part #54530-VL0-S01) that controls the blade brake and/or drive engagement on select Honda HRR216, HRX217, HRN216VKA, and HRR216K9VKAA series walk-behind mowers. It’s the cable that stops the blade when you release the handlebar bail.

Fitment & Compatibility

Before buying, confirm your mower’s exact model and serial number. This cable fits:

• HRR216 series (e.g., HRR216K9VKAA, HRR216TDA, HRR216VKA)
• HRX217 series (e.g., HRX217K5VKA, HRX217HZA)
• HRN216VKA series
• HRR216K9VKAA specifically

Measure your old cable’s overall length (including fittings) – this cable is approximately 48–50 inches long. Check that your mower uses a single-bail brake system (not the dual-bail “Versamow” setup on some HRX models). If your mower has a separate drive cable, this is only the brake cable. Compare the end fittings (one small barrel, one larger loop) to your old part.

Key Things to Know

• OEM quality – This is a genuine Honda part, not an aftermarket copy. Expect correct fit, but inspect the plastic end fittings for cracks during install.
• Moderate install – You’ll need to remove the handlebar cover, unhook the old cable from the brake arm and bail lever, then route the new cable exactly as the old one ran. A cable lubricant helps.
• Common gotcha – The cable can be tight to seat in the brake arm. Use pliers to gently press the barrel into the slot. Do not force it.
• Low review count – Only 3 reviews at 3.5 stars. Likely reflects a small sample, not a design flaw.

Should You Buy It

If you have a compatible Honda HRR216, HRX217, or HRN216VKA mower and the brake cable is frayed, sticky, or snapped, this is the correct OEM replacement. It’s a straightforward fix for DIYers comfortable removing the handlebar cover and rerouting a cable. For non-Honda mowers or different brake systems, look elsewhere.