532447570 Drive Control Cable Compatible with Craftsman Husqvarna 21" 22" Self Propelled Walk-Behind Lawn Mowers Model 917290800 917370440-917370448

What It Is

This is a replacement drive control cable (OEM part 532447570) that engages and disengages the self-propel drive system on compatible Craftsman and Husqvarna 21" and 22" walk-behind mowers. It replaces a worn or broken cable that has snapped, stretched, or become stuck, restoring smooth forward motion control.

Fitment & Compatibility

Before buying, verify your mower’s model number (not just the brand). This cable fits specific Craftsman models like 917290800 and the 917370440-917370448 range, plus select Husqvarna self-propelled mowers with 21" or 22" decks. Check that your mower uses a single drive control cable (not a dual-cable or variable-speed system). Measure the old cable’s overall length (including housing) – this cable is approximately 42-44 inches long. OEM part number 532447570 is the direct replacement; aftermarket versions may vary slightly in housing end fittings, so compare your old cable’s connector shapes (L-bracket, barrel, or eyelet ends) before buying.

Key Things to Know

• Quality: Aftermarket versions are often fine, but check that the cable is pre-lubricated and the housing is kink-resistant. A cheap cable can bind or corrode quickly.
• Installation difficulty: Moderate. You’ll need to remove the handlebar cover, disconnect the old cable from the drive lever and transmission arm, route the new cable, and adjust tension. Expect 20-40 minutes.
• Common gotcha: The cable must be routed exactly as the original – sharp bends or pinching will cause premature failure. Take a photo before removing the old cable.
• Adjustment: After installation, test drive engagement. If the mower creeps or doesn’t engage fully, adjust the cable barrel nut or clamp near the transmission.

Should You Buy It

Buy this if your Craftsman or Husqvarna 21"/22" self-propelled mower has a broken, stiff, or stretched drive cable and you want a direct-fit replacement under $20. It’s a good value for restoring self-propel function without replacing the whole drive system. Skip it if your mower uses a different cable length or connector style – measure first.