50" Mower Deck Belt Made with Aramid Cord for Toro 119-8820 TimeCutter SS5000 SS5060 Replacement Parts Belt, 1/2" x 141 1/2"

What It Is

This is a 50-inch mower deck drive belt reinforced with aramid cord, designed to transfer engine power to the blades on Toro TimeCutter SS5000 and SS5060 zero-turn mowers. It replaces OEM part number 119-8820 and is a direct-fit replacement for the factory belt.

Fitment & Compatibility

• Deck size: 50-inch cutting deck only – not for 42" or 60" decks.
• Models: Toro TimeCutter SS5000 (2013-2018) and SS5060 (2013-2018). Verify your model number on the frame tag under the seat.
• OEM vs aftermarket: This is an aftermarket belt using aramid cord (like Kevlar) instead of standard polyester. It matches OEM specs but is not Toro-branded.
• Measurements: 1/2 inch wide x 141 1/2 inches long (outside circumference). Measure your old belt end-to-end to confirm length – a wrong length will cause poor blade engagement or belt slip.

Key Things to Know

• Aramid cord provides higher tensile strength and heat resistance than standard rubber belts, which can extend life on heavy-use mowers.
• Installation difficulty: Moderate – you’ll need to remove the deck or at least the belt covers and idler pulley tension. A belt routing diagram is helpful (check your owner’s manual or online).
• Common gotcha: The belt must be routed correctly around all three spindle pulleys and the tensioner. If the belt flips or runs off, check for a seized idler pulley or worn spindle bearings first.
• Break-in period: Expect some initial dust or slight stretching during the first hour of use; re-check tension after two mows.

Should You Buy It

If you own a Toro TimeCutter SS5000 or SS5060 with a 50-inch deck and need a reliable, cost-effective replacement for the OEM belt, this is a solid choice. The aramid cord adds durability for frequent mowing, but double-check your deck size and belt length before ordering – wrong fitment will waste time and money.