490-850-0005 Lawn Mower Blade Removal Tool with Mower Blade Blancer | lawn mower blade sharpener tool cub cadet blade removal tool 490-850-0005 blade removal tool lawn mower blade holder

What It Is

This is a two-in-one tool set: a blade removal tool (to hold the blade while you loosen/tighten the spindle nut) and a blade balancer (to check blade balance after sharpening). It’s designed for Cub Cadet, MTD, Troy-Bilt, and other common lawn tractors with a standard spindle nut configuration.

Fitment & Compatibility

• Deck size: Works on most 30–54 inch decks, but not zero-turn or commercial spindles with unusual nut sizes.
• Nut size: Fits standard 5/8-inch or 15/16-inch spindle nuts (check your nut before buying).
• Brand fit: Direct fit for Cub Cadet, MTD, Troy-Bilt, and many Yard Machines. Not compatible with John Deere or Husqvarna unless you verify nut size and blade hole pattern.
• OEM vs aftermarket: This is OEM Cub Cadet (part number 490-850-0005). Aftermarket versions exist but often have looser fit on the balancer.
• Measurements: The removal tool’s slot is about 1/4-inch wide and fits most standard blade holes. The balancer cone fits blades with a center hole up to 3/4-inch diameter.

Key Things to Know

• Installation difficulty: Very easy – just slide the removal tool under the blade against the deck housing to lock it, then loosen the nut. No special skills needed.
• Quality: The balancer is plastic and can warp if left in direct sun or heat. The removal tool is stamped steel – durable but can bend if you use a breaker bar.
• Common gotcha: The removal tool only works on blades that have a slot or hole that aligns with the tool’s tab. Some aftermarket blades have a different hole pattern – test fit before forcing.
• Balancer tip: For accurate balancing, clean the blade and center hole of debris first. The balancer relies on a simple cone – it’s adequate for most mowers but not precision-grade.

Should You Buy It

Yes, if you own a Cub Cadet, MTD, or similar lawn tractor and want a cheap, simple way to remove and balance blades without buying separate tools. It’s perfect for DIY homeowners doing seasonal blade swaps. Skip it if you have a zero-turn, commercial mower, or blades with non-standard hole patterns – you’ll need a more robust setup.