2PK 596-308 for Wright 32 inch Stander Gator Mulching Mower Blades 71440002

What It Is

This is a two-pack of mulching blades (part 596-308) designed for Wright 32-inch Stander Gator mowers, model 71440002. They are intended for fine grass clipping mulching, not side discharge or bagging.

Fitment & Compatibility

• Deck size: Only fits Wright 32-inch Stander decks (model 71440002). Will not fit 36-inch or 48-inch decks.
• OEM vs aftermarket: These are genuine Wright OEM blades, not third-party. Match factory part number 596-308.
• Measurements: Each blade is approximately 16.25 inches long, 2.5 inches wide, with a 5/8-inch center hole and two offset lift wings. The center hole is round (not star-shaped) and fits standard Wright spindle bolts.
• Check before buying: Confirm your deck model number (stamped on deck underside). Measure your current blade length and center hole diameter. Ensure your spindle bolt pattern matches (common on Wright Stander Gator 32).

Key Things to Know

• Installation: Medium difficulty. You’ll need a socket wrench and a blade removal tool or block of wood to prevent spinning. Torque spindle bolts to 70-80 ft-lbs.
• Sharpening: These are mulching blades with a curved wing design—resharpening is possible but tricky. Many users replace rather than sharpen due to the wing profile.
• Gotcha: The blades are directional. The lift wings must face upward toward the deck when installed. Installing upside down will cause poor cut and vibration.
• Durability: Heat-treated steel holds an edge decently for residential use but may dull faster on sandy or rocky lawns.

Should You Buy It

Buy this if you own a Wright 32-inch Stander Gator and want OEM-grade mulching blades for a fine, even cut without clumping. Skip if you have a different deck size or prefer universal/aftermarket blades for lower cost.