17850-VG3-D01 Mower Throttle Lever Cable Compatible with Honda HRR216 HRS216 HRT216 HRZ216 Lawn Mowers, Throttle Lever Control Cable Replacement

What It Is

This is the throttle lever control cable assembly for Honda HRR216, HRS216, HRT216, and HRZ216 series walk-behind mowers. It connects the throttle lever on the handle to the engine carburetor, allowing you to adjust engine speed (fast/slow/choke) from the operator position.

Fitment & Compatibility

Before buying, confirm your mower’s model number (e.g., HRR216K9 VKAA) – the series alone isn’t enough. This cable fits 2000s-era Honda mowers with GCV160/GCV190 engines. Measure your existing cable length: OEM is roughly 38 inches from housing end to end. Check that your mower uses a single-lever throttle control (not a remote choke or separate fast/slow switch). This is an OEM Honda part (17850-VG3-D01), so it matches factory specs – no aftermarket fitment guesswork.

Key Things to Know

• Installation difficulty: Moderate. You’ll need to remove the handlebar cowl, unhook the old cable from the carburetor linkage, and route the new cable through the handle tube. Allow 30–45 minutes.
• Common gotcha: The cable housing must be fully seated in the handle bracket and engine bracket – if it’s loose, the lever won’t return to idle or choke properly.
• Quality: OEM Honda cable with metal ends and nylon liner – more durable than generic replacements. The plastic adjuster nut can crack if overtightened, so hand-tighten only.
• No extra parts: You may need a new zip tie or two to secure the cable along the handle. No special tools required beyond a Phillips screwdriver and pliers.

Should You Buy It

If your Honda HRR/HRS/HRT/HRZ mower’s throttle lever is stiff, stuck, or broken, and you want a direct OEM replacement with no modification, this is the right part. It’s priced fairly, fits correctly, and is much cheaper than buying a new handle assembly. Skip it if you have a different Honda series (like HRX) or a mower with a different cable length.