15pcs Gasoline Engine Recoil Starter Pull Handle, Starter Handle for Honda GX120 GX160 GX200 GX240 GX270 GX340 GX390 Lawn Mower

What It Is

This is a 15-piece set of replacement recoil starter pull handles designed for Honda GX-series small engines. It’s used to manually crank the engine when the original handle breaks or the rope wears out on lawn mowers, pressure washers, generators, and other power equipment.

Fitment & Compatibility

• Confirmed engine models: Honda GX120, GX160, GX200, GX240, GX270, GX340, GX390. Does not fit GCV or GXV series engines without modification.
• Measure the original handle: The plastic handle length is about 4.5 inches; rope diameter is typically 3.5mm (0.14 inches). If your original is thicker or thinner, this set may not match.
• OEM vs aftermarket: This is a generic aftermarket set, not Honda OEM. It will fit most stock recoil housings on the listed engines, but some cheap clones may have slightly different rope length or handle hole size.
• What to check: Verify your engine model number (stamped on the blower housing or valve cover). If your mower uses a different brand engine (Briggs & Stratton, Kohler, etc.), this will not fit.

Key Things to Know

• Quality is adequate for the price. The plastic handles are durable but not as robust as OEM Honda parts. The rope included is standard 3.5mm nylon—fine for occasional use but may fray faster under heavy use.
• Installation is straightforward. You’ll need to remove the recoil housing, thread the new rope through the pulley, tie a knot, and reassemble. No special tools required, but watch a YouTube video for your specific engine if you’ve never done it.
• Common gotcha: The rope length in each handle is pre-cut to about 24 inches. If your original rope was longer (e.g., on large-frame engines), you may need to buy separate rope.
• You get 15 handles—enough to replace multiple mowers or keep spares. But if you only need one, a single OEM handle is often cheaper.

Should You Buy It

Buy this if you have multiple Honda GX-series engines and want a cheap, bulk replacement solution for broken or worn pull handles. Skip it if you need a single, OEM-quality handle for a high-use machine—buy a genuine Honda part instead for better longevity.