115-9649-03 High Lift Notched Mower Blades Compatible with T oro Titan ZX MX Time Cutter 60 inch Deck ZX6000 ZX6020 ZX6030 ZX6050 MX6000 (3 Pack)

What It Is

These are aftermarket high-lift notched mower blades designed for Toro 60-inch zero-turn decks, optimized for superior grass lifting and discharge in heavy or wet cutting conditions. The 3-pack replaces three blades on select Toro Titan, ZX, MX, and TimeCutter models.

Fitment & Compatibility

Deck size: Fits only 60-inch Toro decks. Not for 42", 50", or 54" decks.
Models confirmed: Toro Titan ZX6000, ZX6020, ZX6030, ZX6050, MX6000, MX6050, and TimeCutter 60-inch models (check your specific year).
OEM cross-reference: Replaces Toro part numbers 115-9649 (original) and 117-5758 (updated).
Measurements: Blade length is 20.5 inches, center hole is 1 inch, and the notch is for a 7/16" bolt. Measure your existing blade to confirm length and hole size before ordering.
Warning: High-lift blades may not fit under all decks with tight clearance—verify blade-to-deck clearance if you have a low-profile chassis.

Key Things to Buy

• Quality: These are stamped steel, not forged. They are sharp out of the box but may dull faster than OEM in sandy or rocky soil. Expect 15–25 hours of heavy-use life.
• Installation difficulty: Easy—use a socket or impact wrench. Torque to 50–60 ft-lbs. Always lift the deck safely and block it.
• Common gotchas: High-lift blades increase engine load and can cause clumping in very dry grass. They also throw debris farther—use a discharge chute or bagger.
• Notched design: The notch reduces vibration and helps with mulching in moderate conditions, but these are primarily for side-discharge cutting.

Should You Buy It

If you have a Toro 60-inch ZT with a side-discharge deck and often cut thick, damp, or tall grass, these blades are a solid, cost-effective upgrade over standard OEM blades. Skip them if you primarily mulch or need maximum blade longevity in abrasive conditions.