112-8818 Brake Cable fits Toro 22" Recycler, 20" Rear Bagging Lawn Mower fits Toro 10642 10603 10641 20314 20316 20323 20330 20331 20338 20339 20350 20351

What It Is

The 112-8818 brake cable is a direct replacement part for the blade brake system on Toro 22" Recycler and 20" Rear Bagging lawn mowers. It controls engagement and disengagement of the blade brake when the operator releases the handlebar control lever.

Fitment & Compatibility

• Deck size: Fits 22" Recycler and 20" Rear Bagging models only. Measure your deck width before ordering.
• Model numbers: Confirmed fit for Toro models 10642, 10603, 10641, 20314, 20316, 20323, 20330, 20331, 20338, 20339, 20350, 20351. Check your mower’s model plate under the rear flap or on the frame.
• OEM vs aftermarket: This is a genuine Toro OEM part, not a generic replacement. Aftermarket cables may differ in length or routing.
• Cable length: Approximately 42 inches. Measure your old cable from end to end (including fittings) to confirm.
• Routing: The cable runs from the handle control down to the brake assembly near the blade housing. Check that your mower uses a single-cable brake system (not a dual-cable or bail-type).

Key Things to Know

• Installation difficulty: Moderate. Requires removing the handlebar, routing the cable through clips, and adjusting tension at the brake arm. Allow 20-30 minutes.
• Common gotcha: The cable housing end must seat fully into the brake lever bracket. If it pops out, the brake won’t disengage. Use pliers to crimp the bracket closed slightly if loose.
• Quality: OEM Toro construction with zinc-coated inner wire and plastic-coated housing. Holds up well to seasonal use, but avoid kinking the housing during installation.
• No extra hardware included: You’ll need a 10mm wrench and possibly a flathead screwdriver for adjustment. The cable comes as a single piece with pre-attached fittings.

Should You Buy It

If your Toro Recycler or Rear Bagging mower’s blade brake lever feels loose, doesn’t return to the “brake on” position, or the mower won’t start unless the lever is held down, this cable is likely the issue. At $9.25 with a 4.9-star rating, it’s a reliable, low-cost fix for a common wear item. Best for DIY owners comfortable with basic handlebar disassembly and cable routing.